Members Video and EQ Station Information.
M0AOV Other Members Setups EQ Setup Audio Layout

MIC2200 Info:- Buttons pressed in are MIC/Line - LO Cut - EQ In/Out - Tuning Nob’s are Mic gane=40db - Feq Hz 50 - Feq 500 - Bandwidth 1.4 -Db Level 10 - Db Out +4

If you look at the Picture to the left you will see what I mean.

MDX2200 Info:- Buttons pressed in are Release - SC Filter - IN/OUT - Tuning Nob's are Threshold -35 - Ratio 3 - Threshold -5 - Ratio 2.5 - Attack 50 - Release 0.25 - Output 0 - Threshold +12

If you look at the Picture to the left you will see what I mean.

EX3200 Info:-


From Left To Right

DSP1124P Info:-

Channel 1
SHIFT = Set to Ultra Low (Light on)
BASS PROCESSOR = Set to "1"
MODE = Set to Soft (light off)
AUTO NR = Set to IN (Light on)
NR SENSITIVITY = Set to where the LED Display just barely goes to full scale on voice peaks
TUNE = Set to 3.3
PROCESS = Set to Exciter
HIGH MIX = Set to "1" (be careful with this as it will introduce "Tearing" into the audio if set to high)
SOLO = Set to Off (Light is out)
IN = Set to IN (Light is on)
SURROUND = Set to IN (Light is on)
SURROUND = Control set to "1-2"
Channel 2
SHIFT = Set to Ultra Low (Light on)
BASS PROCESSOR = Set to "1"
MODE = Set to Soft (light off)
AUTO NR = Set to IN (Light on)
NR SENSITIVITY = Set to where the LED Display just barely goes to full scale on voice peaks
TUNE = Set to 3.3
PROCESS = Set to Exciter
HIGH MIX = Set to "1" (be careful with this as it will introduce "Tearing" into the audio if set to high)
SOLO = Set to Off (Light is out)
IN = Set to IN (Light is on)
SURROUND = Set to IN (Light is on)
SURROUND = Control set to "1-2
From Left To Right
From Left To Right
Click Here For
Page 2
More Infomation to HELP you
The information Above is Only There To Guide You, Everyone’s Audio Is Different
So You Will Have To Change The Settings To Tailor Them To Your Voice.
For MORE settings for YOUR equipment Download this FILE the SETTINGS
might help you
These settings will only work if you have the same equipment